Una struttura costituita da un profilo a I è incorporata nei supporti delle forche. The axial rotation is restricted on both ends while warping is enabled. The structure is loaded by two transverse forces in the middle. The verification example is based on the example introduced by Gensichen and Lumpe.
Una trave reticolare piana composta da quattro aste inclinate e un'asta verticale è caricata nel nodo superiore per mezzo di una forza verticale e una forza fuori dal piano. Assuming the large deformation analysis and neglecting the self-weight, determine the normal forces of the members and the out-of-plane displacement of the upper node.
Un'asta ASTM A992 a forma di W è selezionata per sopportare un carico permanente di 30.000 kip e un carico variabile di 90.000 kip in trazione. Verify the member strength using both LRFD and ASD.
Considera una trave ASTM A992 W 18×50 per campata e carichi permanenti e permanenti uniformi come mostrato nella Figura 1. The member is limited to a maximum nominal depth of 18 inches. The live load deflection is limited to L/360. The beam is simply supported and continuously braced. Verify the available flexural strength of the selected beam, based on LRFD and ASD.
Una molla elicoidale strettamente avvolta è caricata da una forza di compressione. The spring has middle diameter D, wire diameter d, and it consists of i turns. The total length of the spring is L. Determine the total deflection of the spring for the member model and one‑turn deflection for the solid model.
Un'asta leggermente inclinata è caricata da una forza concentrata, trattenuta da una molla ad un'estremità e supportata all'altra estremità. Assuming large deformations and neglecting the member's self-weight, determine its maximum upward deflection.
Una struttura composta da un profilo a I è completamente fissata all'estremità sinistra e incorporata nel supporto scorrevole all'estremità destra. The structure consists of two segments. The self-weight is neglected in this example. Determine the maximum deflection of the structure, the bending moment on the fixed end, the rotation of segment 2, and the reaction force at point B by means of the geometrically linear analysis and the second-order analysis. The verification example is based on the example introduced by Gensichen and Lumpe.
Uno sbalzo a parete sottile di un profilo QRO è completamente fissato all'estremità sinistra e l'ingobbamento è abilitato. The cantilever is subjected to torque. Small deformations are considered, and the self-weight is neglected. Determine the maximum rotation, primary moment, secondary moment, and warping moment. The verification example is based on the example introduced by Gensichen and Lumpe.
Uno sbalzo con profilo a I è supportato sull'estremità sinistra e caricato dalla coppia. The aim of this example is to compare the fixed support with the fork support and to investigate the behavior of some representative quantities. Comparison is also made to the solution by means of plates. Small deformations are considered, and the self-weight is neglected. Determine the rotation in the midpoint of the cantilever, and in case of the member entity with warping, determine the values of the primary torsional moment, the secondary torsional moment, and the warping moment both on the left end (point A) and the right end (point B).